How to prolong the life of piranha LED lamp beads? How to effectively prolong the service life of piranhas LED SMD lamp beads is a question worth talking about. The choice of LED lamp quality is a very important factor. Different packaging processes can have a considerable impact on the quality of the product. The LED light encapsulated with a common primer is 76% less luminous decay than the LED light encapsulated with a Class A low-fat glue under the same aging conditions. Therefore, choosing an LED lamp made with a good packaging process will greatly extend its service life. Shenzhen piranha LED manufacturers where good? Shenzhen Yuliang Optoelectronics has more than 20 years of production strength, leading technology and quality assurance. The selection of Shenzhen Yuliang's LED lamp beads is the primary condition for extending its service life.
In order to prevent moisture, led to be stored in a dry and ventilated environment, storage temperature is -40 °C - +100 °C, relative humidity below 85%. It is better to use the LED within 3 months under its original packaging condition to avoid rusting of the bracket. When the LED packaging bag is opened, it should be used as soon as possible. At this time, the storage temperature is 5°C-30°C, and the relative humidity is below 60%.
2, clean
Do not form during welding or after welding. Forming must be completed before welding if necessary. Remember that the behavior of any extruded resin can damage the gold wire inside the LED.
During the welding process, do not apply any external pressure to the lamp body, otherwise there may be cracks inside the LED, which will affect the internal gold wire connection and cause quality problems. Colloids must not be immersed in solder. When welding, the welding point should be at least 2 mm away from the lower edge of the colloid. After the welding is completed, it is necessary to use three minutes to allow the LED to return to normal temperature from a high temperature. If soldering iron is used to solder linearly arranged LEDs on the same PCB, do not solder both pins of the same LED at the same time. Soldering iron requires 30W or less soldering iron. There are two specifications for LED welding. The specific parameters are as follows:
All equipment and instruments that contact led must be grounded;
All personnel in contact with the led must wear anti-static wrist straps or anti-static gloves; do not take products with bare hands
If led is damaged by static electricity, it will show some bad characteristics, such as increased leakage current, static forward voltage drop or rise, in the low current test is not lit or light is not normal, when the customer is in use, please follow the welding precautions or Telephone consultation Shenzhen Yu Liang Optoelectronics Technology Co., Ltd. 0755-29089991, our customer service will be enthusiastic for you.
